Power Saving Modes; Sleep; Green/Standby - TransAct Epic 3000 Programmer's Manual

Epic 3000 Programmer's Guide
Error Vector Taken
Knife Error
Flash File system Error
User Store Fault
Configuration Fault
Flash Read/Write Error
Dynamic Memory
Allocation
Font system Fault
Static Memory Allocation
Communications Fault
Kernel Fault
Head Connection Fault
USB Fault

Power Saving Modes

Sleep

In Sleep mode, the EPIC 3000 printer enters a low power state where everything but the
communications is disabled. In this mode, the printer may be reactivated by command
or by pressing the Power Button. As the print head preheat is turned off, it may take a
few seconds for the EPIC 3000 to warm up the print head in preparation for printing.
This mode is activated by command only. (See page 238)

Green/Standby

In Green mode, the EPIC 3000 printer enters a lower power state where everything
including the communications is disabled. The printer will enter and leave Green mode
based on the Vbus signal on the USB link. This allows the printer to enter a low power
state whenever the USB link is placed in a low power state.
The operational state of the EPIC 3000 can be determined by looking at the Power
Indicator Light (LED). When the printer enters ON mode, the green power indicator light
will be activated. When in Sleep mode, the Power Indicator Light (LED) will blink about
every 3 seconds. In Green mode, the Power Indicator Light (LED) will blink about every
5 seconds.
100-14362
4 Blinks
5 Blinks
6 Blinks
7 Blinks
8 Blinks
9 Blinks
10 Blinks
11 Blinks
12 Blinks
14 Blinks
15 Blinks
16 Blinks
17 Blinks
Rev A
Programming Codes
On Off
On Off
On Off
On Off
On Off
On Off
On Off
On Off
On Off
On Off
On Off
On Off
On Off
Page 25