Table of Contents
Advertisement
T480 Unicode and Fonts
The following table lists the commands and how they interact.
Command
[ESC] + P,
[ESC] + p
[ESC] + P,
[ESC] + p
[ESC] + I,
[ESC] + i
[ESC] + I,
[ESC] + i
[ESC] + J,
[ESC] + j
[ESC] + J,
[ESC] + j
[ESC]I <n>
Function
Set minimum character height and width in points.
ASCII
[ESC] + P <w><h>
Hexadecimal 1BH 2BH 50H
Decimal
<27> <43> <80>
w = 0, 4 – 72 h = 4 - 72
Range
The [ESC] + P command will set the minimum character width or height based on "w" for
the width and "h" for height, where "w" and "h" are in points, defined as 1/72
increments.
If the character width is set to zero, the height will be used for the width and proportional
spacing will be used.
NOTE: The set pitch command will take precedence unless this command
selects 0 width.
Page 210
Zero
Character
width
Width 0
Same as
Height
Width
From
Not Zero
Command
Value 0
No effect
Value
No effect
Not zero
Value 0
No effect
Value
No effect
Not zero
From
POR.INI
definition
Rev A
T480 Programmer's Guide
Character
Cell Width
height
From
From Font
command
From
Based on
command
set character
spacing
command
No effect
From Font
No effect
From
Command
No effect
From Font
No effect
A multiple of
the value
defined by the
command
From
As defined by
POR.INI
command
definition
Pseudo Fixed
pitch flag
No effect
Will be used if
previously set
and character
spacing is not
being defined
by the font
Set Off but has
no effect
Set Off
Set On but has
no effect
Set On
Will be used if
previously set.
All
nd
of an inch
100-14362
Advertisement
Table of Contents
