Figure 8 Connecting The Ac Power Cord (With Power Supply) - TransAct BANKjet 1500 Operator's Manual

2 2 2 2
) ) ) ) . . . .
. 0 . 9 F . 0 . 9 F . 0 . 9 F . 0 . 9 F 0 0 0 0
. 0 . 0 . 0 . 0
1. Orientate the printer upside-down and find the BANKjet's power supply's power socket.
2. Locate the power cord and connect it to the power socket (power supply) located on the back of the printer and
to an external power outlet. The socket-outlet shall be installed near the equipment and shall be easily
accessible.
3. Route the power cord through the cable restraints. Refer to the drawing below to see how to route the cord.
Failure to use the cable restraints may result in the printer becoming accidently unplugged during operation.
Set the printer into OPERATIONAL/ON mode by pressing the * Button. The printer takes approximately 1.5
4.
seconds to begin operation.

Figure 8 Connecting the AC Power Cord (with power supply)

Revision E
5 5 5 5 0 0 0 0 % % % % A A A A
3 " % 3 " % 3 " % 3 " % % % % %
C 0 C 0 C 0 C 0 0 0 0 0
:> ? :> ? :> ? :> ? 0 0 0 0 E E E E
% % % % 0 0 0 0
D D D D
5 5 5 5 # # # # 0 0 0 0 % % % %
% % % % 3 3 3 3
6