Table of Contents
Advertisement
Programming Codes
Composite Barcode Print Options
Function
Composite Barcode control
ASCII
[ESC] [EM] c <f> <v>
Hexadecimal 1BH 19H 63H <f> <v>
Decimal
<27> <25> <99><f> <v>
IPCL
None
Description This command alters the way Composite barcodes are generated and
printed.
Where
f = Feature to control and v = the value of the feature.
f = W 57H, 87D
f = M, 4DH, 77D
f = G, 47H, 71D)
f = K, 4BH, 75D
Note :The normal HRI options do not affect Composite barcodes. Composite
barcode HRI may be on or off and you may select the font. HRI is only
available below barcode.
Page 158
Set the minimum element width.
v = 1-3, 2 is the default and height.
A width of 1 may be unreadable.
It the barcode will not fit in the print zone, the printer will
automatically reduce the width until the barcode will fit. If
the barcode will not fit at a width of 1, the printer will not
print the barcode.
Composite CC mode. 1-3 are accepted. 0 – Auto
0=Auto, 1=CC-A, 2=CC-B, or 3=CC-C.
GS1 Mode. (See General description above)
If in GS1 mode the symbol start with an FNC1 and that the
compression is slightly altered. GS1 data formatting and
compaction are active and the input must follow the GS1
rules.
HRI On and Font.
f =0 – Off, F=1 - Medium, f=2 - Larger, f=3 - Smaller (Note:
Fonts may be redefined by using the change legacy font
command. Note that this command referances font offset
by 1)
Rev A
T480 Programmer's Guide
100-14362
Advertisement
Table of Contents
