TransAct Epic 3000 Programmer's Manual page 181

Epic 3000 Programmer's Guide
[ENQ] <33> Inquire Paper Size.
ASCII [ENQ] <33>
Hexadecimal 05H 21H
Decimal <5> <33>
Function The [ENQ] <33> command Paper Size Status.
Response [ACK] <33> <41> <n>
Where
<33> Is the echo of command
<41> Length + 40
<n> Paper Size Statu.
bit 0,1 0 = 40 mm paper
bit 2 = Not defined 0 always
bit 3 = Not defined 0 always
bit 4 = 1 40mm paper divider installed.
bit 5 = Not defined 0 always
bit 6 = 1 always
bit 7 = 0 always
[ENQ] <34> Inquire Firmware ID and Rev.
ASCII [ENQ] <34>
Hexadecimal 05H 22H
Decimal <5> <34>
Function The [ENQ] <34> command returns the Firmware ID and revision.
Response [ACK] <34> <51> PE9100-X.XX.
Where
<33> Is the echo of command
<51> Length + 40
Firmware ID PE9100
Separator - (0x2D or 45D)
Rev X.XX (Current Revision in ASCII)
15
In some cases a small 58 mm paper print zone is used on 40mm paper although some of the
print may miss the paper.
100-14362
1 = 58 mm paper (Note
2 = 80 mm paper
3 = 82 mm paper
Rev A
15
: 40mm can be reported as 58mm)
Programming Codes
Page 181