Information Regarding The Quality Seal; Entering The Bar Code - Sirona CEREC MC XL Operating Instructions Manual

6 Operation
6.4 Entering the bar code
36
6.3.5 Information regarding the quality seal (CEREC MC XL
with premium package)
Proper selection and processing of the material are decisive for the long-
Fragment Seal of approval
term clinical success of the restoration, especially in the case of zirconia.
However, different types of zirconia require individually matched machine
parameters. This is the reason why you can and must select different
types of zirconia in the inLab software. These machine parameters are
coordinated between Sirona and its material partners in complex
development processes. In addition to the desired fit and surface quality,
they also guarantee a maximum degree of material and equipment
safety. The consistently high quality of the production results and the fit
can only be guaranteed and damage to the production machines can only
be excluded if certified materials are used.
NOTICE
Block without seal of approval
If a block is found without a seal of approval during the production
process (milling or grinding), the following message appears:
„No quality label was recognized on the block. The grinding and milling
processes as well as the instruments are specially verified for certified
materials. Certified materials can be identified by the engraved "inLab"
lettering on the block. The use of zirconium oxide materials without
quality label can lead to inferior results as well as increased wear on the
device and instruments.
Do you still wish to start the manufacturing process?"
6.4

Entering the bar code

Barcode Reader active
Bar code reader active
If you have activated the option
configuration dialog (e.g. for inCoris ZI), you must read-in both bar codes
with the bar code reader. To do this, hold the bar code reader tilted to a
slight angle and move it over both of the bar codes on the block
continuously and evenly.
If the reading process fails, you can read-in the bar code once again by
"Retry"
pressing
enter the substitute code (8-digit character string, e.g. *1234XYZ) on the
PC manually.
No bar code reader available
No bar code reader available
➢ Enter the substitute code (8-digit character string, e.g. *1234XYZ) on
the PC manually.
Operating Instructions CEREC MC XL
"Barcode Reader"
(button 1 on the unit display). Alternatively, you also can
Sirona Dental Systems GmbH
in the system
61 46 885 D 3439
D 3439.201.02.19.02 12.2014