Operation; Configuration (Cerec Mc Xl) - Sirona CEREC MC XL Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions CEREC MC XL
61 46 885 D 3439
D 3439.201.02.19.02 12.2014
6

Operation

CAUTION
Risk of injury on calibration pins/instruments
If you reach into the grinding chamber (e.g.: when inserting/removing a
ceramic block, changing instruments or inserting/removing a calibration
phantom), you may injure your hand on the calibration pins/instruments.
Be careful not to brush against the calibration pins/instruments with your
hand.
Always insert your hand in the grinding chamber underneath the
calibration pins/instruments.
6.1

Configuration (CEREC MC XL)

"Devices"
In the area of the CEREC SW software, various settings can be
Description
subsequently modified.
"Configuration"
1. Click the
"Devices"
2. Click on the
3. Click on the unit that you wish to configure.
De-activating an instrument set (only for grinding units with 4 motors)
Title: De-activating the CEREC bur set
You may need to deactivate an instrument set, e.g. unless it is possible
Description of deactivation of the Premium Package bur set
to replace a defective instrument or in case a grinding motor is defective
or cannot be calibrated.
In all of these cases, you can deactivate sets 1 and 2 separately. A
deactivated set will simply be ignored during production, calibration etc.
NOTICE
Milling tools may only be used in set 1.
NOTICE
Risk of collision
The restoration may become damaged if longer instruments are present
in the deactivated instrument set than in the active set.
➢ Ensure that the instruments installed in the deactivated instrument
set are not longer than those in the active set.
➢ You can deactivate an instrument set by removing the check mark in
front of the instrument set in the software or by deactivating the
instrument set on the touch display under
6.1 Configuration (CEREC MC XL)
button in the system menu.
button.
"Edit Device Settings"
6 Operation
.
27