Communication Command List - Omron ZW Series User Manual

Chapter 5
Connecting Using RS-232C Cable

Communication Command List

Command
name
MS MS <task number>
<delimiter>
JG JG <task number>
<delimiter>
DG DG <unit number>
<data number>
<delimiter>
DS DS <unit number>
<data number>
<setting value>
<delimiter>
BG BG <delimiter>
BS BS <data number>
<delimiter>
ZR ZR <task number>
<delimiter>
ZC ZC <task number>
<delimiter>
TM TM <0:OFF/ 1:ON>
<0><delimiter>
RT RT <0:OFF/ 1:ON>
<0><delimiter>
LD LD <0: ON/1: OFF>
<delimiter>
ZW
5-12
User's Manual
Format Return value
<measured value>
<delimiter>
<judgment result>
<delimiter>
<data> <delimiter>
OK <delimiter>
<bank number>
<delimiter>
OK <delimiter>
OK <delimiter>
OK <delimiter>
OK <delimiter>
OK <delimiter>
OK <delimiter>
*1 Details
Acquires the current measured value. If
the <task number> is omitted, the
measured value displayed is acquired.
If "4" is set for the <task number>, the
measured values for all tasks are
obtained.
Acquires the judgment result of the
specified task. If the <task number> is
omitted, the result of the task of which the
result is currently displayed is acquired.
If "4" is set for the <task number>, the
measured values for all tasks are
obtained.
Acquires the measurement data and
setting data of the processing unit.
Changes the setting data of the
processing unit.
Acquires the current bank number.
Replaces the current bank number by the
specified bank number.
Executes a zero reset for the specified
task. If the <task number> is omitted, the
zero reset is executed for the task of which
the result is currently displayed.
If "4" is set for the <task number>, this is
executed for all tasks.
Cancels the zero reset of the specified
task. If the <task number> is omitted, the
zero reset is executed for the task of which
the result is currently displayed.
If "4" is set for the <task number>, this is
executed for all tasks.
Executes the timing input.
* Calculates OR with the parallel input.
Executes the reset input.
* Calculates OR with the parallel input.
Turns ON/OFF the logical beam.
Refer
p.5-14
p.5-16
p.5-17
p.5-18
p.5-19
p.5-20
p.5-21
p.5-22
p.5-23
p.5-23
p.5-24