Chapter 7
Error Messages and Countermeasures
■ Ethernet communication errors
Error
code
23
25
■ Measurement errors
Error
code
90
If an error code other than the one listed above is displayed, the controller may be broken. Please con-
tact an OMRON branch or sales office.
ZW
7-6
User's Manual
Abnormality
IP address duplication
The same IP address as that
error
of the controller exists on the
network.
Ethernet
An invalid IP address is set.
communication
parameter error
Abnormality
Abnormal
The receiving status (line
measurement
brightness) during
waveform
measurement is not
appropriate.
Cause
A controller with the same IP address
exists on the same network.
Change the IP address setting. (see p.5-5)
An invalid IP address is set for the
controller.
Set an appropriate IP address. (see p.5-5)
Cause
Check if the Sensor cable is disconnected
or broken.
Furthermore, remove the cable from the
controller, and clean the edge surface and
reconnect.
And then calibrate the Sensor Head. (see
p.1-19)
Countermeasure
Countermeasure