Omron ZW Series User Manual page 33

■ Front view
● Display
No. Names (light color)
1 HIGH indicator (orange)
2 PASS indicator (green)
3 LOW indicator (orange)
4 STABILITY indicator
(green)
5 ZERO indicator (green)
6 ENABLE indicator (green) The ENABLE indicator lights when the Sensor is ready for measurement. It
7 Main display (red)
8 Sub-display (green)
9 RUN indicator (green)
10 THRESHOLD-L indicator
(orange)
11 THRESHOLD-H indicator
(orange)
● Control panel
No. Names
12 ZERORST/ESC key
m (LEFT) key
13
o (RIGHT) key
n (UP) key
p (DOWN) key
14 ZERO/SET key
15 Mode switching key
The HIGH indicator is lit while judgment is resulted in HIGH (HIGH
threshold value measured value).
The PASS indicator is lit while judgment is resulted in PASS (LOW
threshold value d measured value d HIGH threshold value).
The LOW indicator is lit while judgment is resulted in LOW (measured
value LOW threshold value).
The STABILITY indicator is lit while a measured value is within the
measuring range.
It goes out if a measured value is out of the measuring range.
The Zero Reset indicator is lit while the zero reset function is enabled.
goes off when measurement is not possible (e.g. when the received light
amount is excessive or insufficient, when the measuring range is
exceeded, when the calibration ROM is not connected, or when
measurement is not being performed in FUN mode).
The main display shows measured values and/or function names.
The sub-display shows additional information for measured values or
setting values for functions.
The RUN indicator is lit in the RUN mode, and goes out in the FUN mode.
The LOW threshold value indicator is lit when the Sub-display indicates a
LOW threshold value.
The HIGH threshold value indicator is lit when the Sub-display indicates a
HIGH threshold value.
These keys function differently depending on operation modes.
Functions of Operating Keys p.2-3
Part Names and Functions
Functions
Functions
Chapter 1
ZW
1-5
User's Manual