Table of Contents
Advertisement
■ Operating mode switching
MODE
ON
BUSY output
OFF
ON
ENABLE output
OFF
Judgment output
(HIGH/PASS/LOW)
Binary output
ON
GATE output
OFF
Analog output
T3
Response time of analog output
T9
Measurement start response time
In FUN mode, there is no binary output. Immediately after the mode is switched to RUN mode, the
clamp value is output until the measured value is applied.
● Explanation of operations
(1)
After the mode is switched from RUN to FUN mode, the BUSY output and
ENABLE output are turned OFF. The judgment outputs all go OFF and the binary
output is output clamped.
(2)
The response time of analog output after the BUSY output is turned ON, the
analog output is output clamped.
(3)
After the mode is switched from FUN mode to RUN mode, the BUSY output is
turned OFF.
(4)
Measurement is restarted and the ENABLE signal is turned ON, then the
measurement results are output.
(1)
T3
RUN
Item
-
3uT0
(2)
(3)
FUN
All OFF
CLAMP
CLAMP
Minimum
0.1 ms
Depends on the set
conditions
Chapter 4
Timing Charts
(4)
T9
RUN
Maximum
ZW
User's Manual
4-43
Advertisement
Table of Contents
