Download Print this page

Setting The Communication Specifications - Omron ZFV-C Command Reference Manual

Smart sensor, non-procedural communication

Hide thumbs Also See for ZFV-C:

Setting the Communication Specifications

Change the settings of the controller communication specifications for non-procedural

communication with the external device.

Use a USB cable or RS-232C cable to connect ZFV-C controllers to external devices.

For the USB cable connection, download and install the USB driver beforehand.

For the USB driver, please contact your OMRON representative.

Switch the controller to [MENU].

Select [System2] - [Communication] to set the appropriate communication

specifications for the external device.

Switch the controller to [RUN]. (This executes the save.)

Communication commands are accepted only in the RUN mode.

ZFV-C

Non-procedural Communication Command Reference

Table of Contents