Tone Setup Menu; Morse Code Menu - Futurecom P25 Installation & Programming Manual

Field Name
Digital
Enable /
Emergency
Disable check
Portable Ack
box
Required
Enable /
TG1 Translation
Disable check
Disabled
box
Switch DVR from
Enable /
LOC to SYS if
Disable check
MSU in
box
Emergency

Tone Setup Menu

The tones setup screen allows programming of custom tones / tone sequences, which are
sent by the DVR to the Analog PSUs during Analog Mode of operation only.
If no custom tones are programmed, the DVR will send the default sets of tones.
NOTE:
The tones sent by the DVR in analog mode are heard by all analog PSUs, which are tuned
to the same DVR channel and are within the DVR RF coverage area.

Morse Code Menu

The Morse code option needs to be programmed only when a DVRS is to be used as a
fixed repeater and the FCC rules require transmission of Repeater ID via Morse Code.
January 2019
DVRS Installation & Programming Guide – PART II
Range Description
Enables / Disables the sending
of low level ACK by the DVRS to
the PSU upon receipt of an
Emergency Alarm.
Default setting is unchecked
(TG1 translation is enabled). In
this case
emergency
default TG1),
translates the TG ID to match
the currently selected MSU TG
ID. This way the emergency is
announced on the selected
MSU TG, not on TG 1, which
may not even exist in the
specific Trunking system.
When the DVR is in the LOC
mode and the user presses the
Emergency button on the MSU
CH the DVR will switch from
LOC to SYS mode when this
option is
checked). If the option is not
enabled, the DVR stays in LOC
mode after
declared on the MSU.
The Emergency ACK type is sent
by the DVR depending on its
programming – VR ACK / Site
(FNE) ACK or Console ACK.
Default setting is Enabled.
when a PSU
is received (on
the DVR
Applicable to Fireground Analog,
Mixed and TPS type DVR
channels.
enabled (box is
Emergency is
8M083X25 R14
APX Series P25 Interface
Notes
Page 85 of 153