Table 11 Summary Of Local Mode Microphone Audio Handling - Programmable Options - Futurecom P25 Installation & Programming Manual

Field Name
600 – 6000
System Channel
Acquisition Time ms
This VR ID number
Fallback to Local Checkbox
Repeat Disabled
Enable Bypass Checkbox
Algorithm for
APX 8500
MSU CPS
MSU System
MSU Mic Call
PTT in Local
Local Repeat
Mode
in LOC Mode

Table 11 Summary of Local Mode Microphone Audio Handling - Programmable Options

January 2019
DVRS Installation & Programming Guide – PART II
Range Description
Determines the DVR wait time for
the system grant before the DVR
decides what tones (ACK or NACK)
must be sent to the Local PSUs
and starts local repeat.
Specifies the ID of the DVR, which
is used for remote DVR mode and
TG change. If not specified, the
DVR will assume the ID of the
currently interfaced MSU.
When this box is checked the
fallback to Local Repeat is disabled
When enabled the algorithm would
assure that MSU In-band filter is in
use only when MSU is operating on
the zone/channel that is in the
same band as DVR.
DVRS
Tweaker Tx Mic Audio
to
FNE/system
No
No
Yes
Yes
APX Series P25 Interface
Notes
This timer also determines the
maximum number of retries that
will be made by the DVRS in
order to acquire a system
channel. These retries are sent
every second so if the intent is to
allow 2 retries, the timer needs to
be set to 1800 – 2000ms in order
to allow sufficient system
response time.
Refer to the Remote DVR
Control / TG Steering Section of
this Document.
Tx Mic
Audio
Comment
To Local
PSUs
Warning:
No functionality disabled,
audio not transmitted
Typical setting for
Yes DVR
No
Yes
8M083X25 R14
MIC
Page 82 of 153