Dvr Common Setup - Futurecom P25 Installation & Programming Manual

DVR Common Setup

Field Name
Local Mode Enable /
Allowed Disable
Check box.
Rptr Enable /
Independent Disable
Channel Change Check box.
Power Up Mode Fixed
Last
Programmed
Fixed Mode System
Local
OFF
Disable –
Channel
max # of
programmed
DVR
channels
Disable –
No Activity Timer
- Repeater 120 min
Display Enable /
PTT ID Disable
check box.
TG ID
Hang Time 0-5 sec
Enable /
Repeater Active
Disable
Tones
check box
Enable /
Local Mode
Disable
Active Tones
check box
January 2019
DVRS Installation & Programming Guide – PART II
Range Description
Enables / Disables Local DVR
Mode selection by the User.
When Enabled the DVR channel
can be selected independently from
the selected MSU channel. When
Disabled, the DVR channel is
strapped to the selected MSU
channel.
Specifies the DVR Mode upon
Power Up. When 'Programmed' is
selected, the DVR Mode is as
programmed for the selected DVR
channel or MSU Mode.
Specifies the DVR Mode when
Fixed Power up option is selected.
Typical recommended setting is
OFF.
Specifies the Default DVR Power
up Channel. If set to Disable, the
DVR reverts to the last used
channel upon Power up.
If the DVR is not active (does not
receive any local PSU calls) for the
programmed period of time, it will
automatically switch from System
or Local to OFF Mode. The DVR
sends warning tones to alert the
Local PSU users every minute
during the last 5 minutes prior to
switching OFF.
Enables / Disables the display of
Portable PTT ID and TG ID on the
Control Head.
Outbound calls TG ID is displayed
(when enabled) during proxied calls
as well.
Determines the hang time during
which the ID remains displayed
after the call has ended.
Enables / Disables the sending of
tones when the DVR is switched to
System (and
Mode. The repeater active tones are
transmitted over the air to all Local
PSUs tuned to the same DVR
conventional channel.
Enables / Disables the sending of
tones when the DVR is switched on
in Local Mode. The repeater active
tones are transmitted over the air to
all Local PSUs tuned to the same
DVR conventional
Requires enabling of the 'Repeater
Active Tones' Field.
APX Series P25 Interface
The DVR can still revert
temporarily to Local mode (when
the System is not available) even
if Local mode is Disabled.
Default setting is Fixed.
If AVRA is Enabled then the
Power Up mode is driven by the
AVRA input.
Default setting for vehicular
mount models is OFF
Outbound calls, received by the
MSU and repeated by the DVR
will not reset the timer.
Tones are sent when switching
optionally Local) from OFF to LOC or OFF to SYS
occurs. Tones are not sent when
switching SYS to LOC or LOC to
SYS.
Tones are sent when switching
from OFF to LOC or OFF to SYS
occurs. Tones are not sent when
switching SYS to LOC or LOC to
channel.
SYS.
8M083X25 R14
Notes
Page 80 of 153