Changing Control Unit Parameters - Otto Bock B400b400 Instructions For Use Manual

Adjusting the control panel to the forearm length
1) Loosen the 3 set screws on the bottom of the armrest.
2) Slide the rail with the control panel forwards or back­
wards.
INFORMATION: If the control panel rail is too long
it can be shortened. Please contact the qualified
personnel who adjusted your product.
3) Tighten the 3 set screws on the bottom of the armrest.
Fig. 6 Adjusting the control panel
Changing the control panel side
By default, the control panel is mounted on the side spe­
cified in the order. It can also be mounted on the other side
later on if the user so desires.
B400
INFORMATION
The control panel mounting side may only be changed by
authorised personnel.

5.3.7 Changing control unit parameters

WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified per­
sonnel trained by the manufacturer. The manufacturer
of the product and the control unit manufacturer are
not liable in case of damage caused by programming
which was not performed properly and/or which was
not adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configura­
tion can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking
or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause
an accident.
► After configuration/programming is complete, the user
must test the driving characteristics of the product
under the supervision of the qualified personnel.
If necessary, the qualified personnel can fit the already pre­
programmed wheelchair control system and accessories to
the specific user requirements.
Preparation for Use
Ottobock | 17