Changing Control Unit Parameters - Otto Bock B500 Classic User Instructions

Fig. 8 Adjusting the control panel
Changing the control panel side
By default, the control panel is mounted on the side spe­
cified in the order. It can also be mounted on the other side
later on if the user so desires.
INFORMATION
The control panel mounting side may only be changed by
authorised personnel.

5.3.7 Changing control unit parameters

WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
B500 classic/advanced
► Programming may only be performed by qualified per­
sonnel trained by the manufacturer. The manufacturer
of the product and the control unit manufacturer are
not liable in case of damage caused by programming
which was not performed properly and/or which was
not adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configura­
tion can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking
or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause
an accident.
► After configuration/programming is complete, the user
must test the driving characteristics of the product
under the supervision of the qualified personnel.
If necessary, the qualified personnel can fit the already pre­
programmed wheelchair control system and accessories to
the specific user requirements.
6 Usage
6.1 Side panels
INFORMATION
For additional information on side panels with lighting: see
Page 58.
Usage
Ottobock | 19