Xtreme Power Conversion M90S Series User & Installation Manual page 72

M90S-4S User's Manual
Measurement:
Input Output
Bypass
Load
Bat
5.4.3 Setting
This page is used to configure the parameter settings. It's necessary to enter password to enter submenus. The
default password is 0729. There are submenus under the Setting, including Bypass, ECO, Output, SystemTime,
Others and Battery, as shown below.
NOTE: Some settings will be only available in some operation modes. If the setting is not available in current
mode, the LCD will show prompt message with "Item can't be set in this mode". Press any button or just wait for
several seconds until this message fades.
Xtreme Power Conversion Corporation
Input:
Volt1: 230.0V
Volt2: 230.0V
Volt3: 230.0V
Freq: 50.0Hz
Phase: 120
Volt1: 230.0V
Volt2: 230.0V
Volt3: 230.0V
Freq: 50.0Hz
Phase: 120 Pout1: 3300VA
Pout2: 3300VA
Pout3: 3300VA
Output
Volt1: 230.0V
Volt2: 230.0V
Volt3: 230.0V
Inv1: 230.0V
Inv2: 230.0V
Inv3: 230.0V
Freq: 50.0Hz
Load:
Sout1: 3300VA
Sout2: 3300VA
Sout3: 3300VA
Uninterruptible Power Supply
Current
Curr1: 15.0A
Curr2: 15.0A
Curr3: 15.0A
<<<<
Load:
Load1: 100%
Load2: 100%
Load3:100%
<<<<<
Page 72