RSscan footscan User Manual page 89

Impulse
Zones
Probes
Load rate
Footprint size Footprint size of the current foot selection (Section 10.13).
Risk analysis
Gait Ratios
COP Graphs
Foot Timing
Full plate
Multi step
The following comparisons are available:
2D
Impulse
Areas
Analyze Toolbar
visualization of the analysis to better suit your needs. Depending on the type of analysis
shown, certain actions are made available:
RS-PRD-00562-016
Impulse analysis of the current foot selection (Section 10.9).
Anatomical zones of the current foot selection (Section 10.10).
Pressure in user-defined areas of the current foot selection
(Section 10.11).
Load rate of the current foot selection (Section 10.12).
Risk analysis gives more information about the risk of the feet in a
dynamic measurement (Section 10.14).
Gait ratios analysis of the current foot selection (Section 10.15).
Center of pressure graphs of the current foot selection (Section
10.16).
Single foot timing analysis of the current foot selection (Section
10.17).
Activity on the plate during the entire dynamic measurement
(Section 10.18).
Multi step analysis of the dynamic measurement (Section 10.19).
2D roll-off comparison of the foot selections (Section 10.20).
Impulse comparison of the foot selections (Section 10.21).
Comparison of pressure distribution of the foot areas (rearfoot,
midfoot, forefoot) of the foot selections (Section 10.22).
Each analysis also features a toolbar. The toolbar lets you control the
Zooms the view to fit the center of pressure line tightly.
Zooms the view to fit its contents tightly.
Zoom in. Alternatively use the mouse's scroll wheel on the view.
Zoom out. Alternatively use the mouse's scroll wheel on the view.
Rotate the view counter clockwise.
Rotate the view clockwise.
Toggles the sensor grid. The sensor grid shows the location of the
plate sensors.
Toggles the display of the center-of-pressure of a pressure
distribution.
89