Pressure Sensitive Layer (Psl) Replacement - RSscan footscan User Manual

4.5 Pressure Sensitive Layer (PSL) Replacement

rs scan recommends to replace the PSL yearly.
Footscan 9 will try to automatically download the pending PSL replacement
list of your footscan device(s). This is done automatically in the background
when the software is starting up. Should footscan 9 detect that a PSL
replacement file is already present on your computer, then footscan 9 will
show a confirmation dialog asking if the PSL was actually replaced on your
footscan device.
There are two ways to replace the PSL of your footscan pressure plate:
Replacement by rs scan: your device is sent back to rs scan through a RMA
procedure. The PSL replacement and factory calibration will be performed by rs
scan and a new calibration file will be made available on the rs scan calibration
server. As soon as you start the footscan 9 software with the pressure plate
connected, the footscan 9 software will download and use the new calibration file.
On-site replacement: a new PSL can be prepared by rs scan and installed on your
pressure plate by a distributor. The new calibration file will be made available on the
rs scan calibration server with a "pending" flag, this means that it must be signaled
to the rs scan calibration server when the PSL is actually replaced. This can be
done in the setting dialog, see section 6.4.
Contact the rs scan support department at
about replacing the PSL.
RS-PRD-00562-016
®
®
®
®
®
®
®
support@rsscan.com
®
for more information
53