Configuration To A Pre-Existing Office Network; Create A Shared Folder On Network File Server - Zeiss Humphrey Matrix 800 User Manual

8-4
Networking Configuration

Configuration to a Pre-existing Office Network

This section explains how to configure the Matrix 800 to communicate via your pre-existing
office network (a local area network or LAN). To do this, the Matrix must be connected to
the office network by a standard network patch cable. It is the user's responsibility to
install the necessary cables. Configuration topics, in order, are:
• Install the Network Cable, page
• Create a Shared Folder on Network File
• Configure Network Settings on the
• Add Network Shared
Selecting a Subfolder in a Network
•
Install the Network Cable
Plug one end of a standard network patch cable into the Matrix Ethernet port (see on
page 1-7). Plug the other end of the cable into the 10/100 network switch. This switch
controls the bandwidth in and out of Matrix. Connect another standard network patch
cable between the switch and the office network outlet.

Create a Shared Folder on Network File Server

To save your Matrix data, a shared folder needs to be created on the network file server, or on
a computer on the local network. For a Windows XP computer, see
on a Windows XP computer
Create a shared folder on a Windows Vista or Windows 7 computer
8-9.
Create a shared folder on a Windows XP computer
1. Create a local folder on the computer for exported data. The new folder can be
created in any available path on the hard disk drive. In the example below, the new
folder was created by right-clicking on the Windows desktop, and then selecting
New > Folder (Figure 8-1).
Figure 8-1 Right-click on Desktop, Select New > Folder
Humphrey Matrix User Manual
8-4
Server, page
Matrix, page
Folders, page 8-14
Share, page 8-17
below. For a Windows Vista or Windows 7 computer, see
2660021138935 Rev. F 2015-11
8-4
8-13
Create a shared folder
on page