Table of Contents
Advertisement
Upgrade System
The Matrix 800 instrument is designed with the ability to upgrade the operating software
using the CD-R/W drive, or from a folder in a USB drive or network location. The total time
for the software upgrade is about 10 to 20 minutes, depending on the source. To upgrade
the Matrix 800 system software:
1. Select File Functions (F4) to display the F
2. In the Upgrade System section, select the browse button (
upgrade location. The Save Location dialog appears
Figure 10-1 Save Location Dialog (Database Restore)
3. To set the upgrade location, select the CD-R/W, Network Share, or USB radio button.
For Network Share and USB, select a location from the corresponding drop-down
menu. For Network Share, you must have previously added network shared folders to
select them here (see
Add Network Shared Folders
information on USB storage devices see
Note: The upgrade location is remembered after instrument shutdown. The selected
Network Share or USB storage device is also remembered after instrument shutdown, until
you change it. However, if you remove the USB device and insert a new USB device, the
new USB device will be selected as the upgrade location.
4. Select OK to set the location.
5. Select Upgrade to start the upgrade.
6. Select OK.
7. A message will be displayed when the upgrade has completed successfully. If you
upgraded with a CD or USB device, you can now remove it.
8. Select OK to restart the instrument.
The H
(F6) Screen will identify which version of the Humphrey Matrix system software is
ELP
installed
(Figure
10-3).
Install Software
The Install Software function on the H
procedure with pre- and post-backup functions to help ensure a safe and complete
upgrade process.
Humphrey Matrix User Manual
Maintenance
F
Screen
(Figure
ILE
UNCTIONS
(Figure
10-1).
on page 8-14). For
USB Storage Devices
Screen integrates the system software upgrade
ELP
2660021138935 Rev. F 2015-11
10-5
7-1).
) to select an
on page 2-10.
Advertisement
Table of Contents
