Acl > Acl Hardware Resource Status; Poe > Poe Global Settings (Des-1210-08P/28P Only); Poe > Poe Port Settings (Des-1210-08P/28P Only) - D-Link DES-1210-08P Reference Manual

4 Configuration
IPv6 Access-List: Add the specified ports in the IPv6 access list group.
Click Apply to make the configurations take effects.
ACL > ACL Hardware Resource Status
The ACL Hardware Resource Status page displays the information of ACL Hardware Resource status.
PoE > PoE Global Settings (DES-1210-08P/28P only)
This page will display the PoE status including System Budget Power, Support Total Power, Remainder
Power, and The ratio of system power supply.
System Power Threshold: Manually configure the system power budget 7.1 ~ 193.0 watts for DES-1210-
28P and 72 watts for DES-1210-08P.
Power Shut Off Sequence: Defines the method used to deny power to a port once the threshold is reached.
The possible fields are:
Deny next port: When the power budget is exceeded, the next port attempting to power up is
denied, regardless of the port priority.
Deny low priority port: The port with the lower priority will be shut down to allow the higher priority
port to power up.
Click Apply to make the configurations take effects.
System Power Status: Displays the system power status of device.
Total PoE Power Budget: Displays the total PoE power budget of this switch.
Power Used: Displays the current used power of the switch.
Power Left: Displays the spare power of the switch.
The percentage of system power supplied: Displays the percentage of system power supplied of
the switch.
PoE > PoE Port Settings (DES-1210-08P/28P only)
DGS-1210-08P/28P supports Power over Ethernet (PoE) as defined by the IEEE specification. It supplies
power to PD device up to 15.4W for all ports or 30W for port 1~4, meeting IEEE802.3af standards and pre-
802.3at standards.
Figure 4.112 - ACL > ACL Hardware Resource Status
Figure 4.113 – PoE > PoE Global Setting
7 5
7 5
DES-1210 Series Switch Web UI Reference Guide