Led Board And Overlay Installation - Keysight Technologies N9030A Installation Note
Pxa signal analyzer. option mtu, multitouch user interface upgrade kit
option mtp, multitouch user interface upgrade kit
with pc6 cpu
Hide thumbs
Also See for N9030A:
- Installation note (8 pages) ,
- Service manual (607 pages) ,
- Installation note (9 pages)
Table of Contents
Advertisement
Option MTU and MTP, MultiTouch User Interface Upgrade Kits
LED Board and Overlay Installation
1. Remove the filter plate to the left of the display. The screws will be re-used, but the filler plate
will not be re-used.
2. Refer to
Figure
25. Locate the LED board (1) that was removed earlier and the
LED board overlay (2) located in the kit.
Figure 25
LED Board and Overlay
38
This procedure only applies to analyzers with Option BBA, BBIQ Analog Inputs. If the analyzer
does not have Option BBA, proceed to the next section.
N9020-80193
Installation Note N9030-90098
Advertisement
Table of Contents
