Keysight Technologies N9030A Installation Note page 11
Pxa signal analyzer. option mtu, multitouch user interface upgrade kit
option mtp, multitouch user interface upgrade kit
with pc6 cpu
Hide thumbs
Also See for N9030A:
- Installation note (8 pages) ,
- Service manual (607 pages) ,
- Installation note (9 pages)
Table of Contents
Advertisement
Replacing Solid State Drive (SSD) - N9030A-MTU Upgrade Only
The steps in this section apply only to N9030A-MTU upgrades, where the solid state drive is
replaced. If the N9030A-MTP upgrade is being performed, skip to"
N9030A-MTP Upgrade
1. Turn off the instrument and remove the AC power cord.
2. Refer to
Figure
2. Locate and remove the existing disk drive carrier assembly (2) from the
instrument by loosening the rear panel screw (1).
Figure 2
Replacing the Disk Drive Carrier Assembly
Installation Note N9030-90098
Option MTU and MTP, MultiTouch User Interface Upgrade Kits
Only".
Replacing CPU Assembly -
11
Advertisement
Table of Contents
