Danfoss VLT FC 300 Operating Instructions Manual page 96

General Specifications
Pulse/encoder inputs
Programmable pulse/encoder inputs
Terminal number pulse/encoder
Max. frequency at terminal 29, 32, 33
Max. frequency at terminal 29, 32, 33
Min. frequency at terminal 29, 32, 33
Voltage level
Maximum voltage on input
Input resistance, R
Pulse input accuracy (0.1 - 1 kHz)
Encoder input accuracy (1 - 11 kHz)
5 5
The pulse and encoder inputs (terminals 29, 32, 33) are galvanically isolated from the supply voltage (PELV) and other high-
voltage terminals.
1) FC 302 only
2)
Pulse inputs are 29 and 33
3)
Encoder inputs: 32 = A, and 33 = B
Digital output
Programmable digital/pulse outputs
Terminal number
Voltage level at digital/frequency output
Max. output current (sink or source)
Max. load at frequency output
Max. capacitive load at frequency output
Minimum output frequency at frequency output
Maximum output frequency at frequency output
Accuracy of frequency output
Resolution of frequency outputs
1)
Terminal 27 and 29 can also be programmed as input.
The digital output is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
Analog output
Number of programmable analog outputs
Terminal number
Current range at analog output
Max. load GND - analog output
Accuracy on analog output
Resolution on analog output
The analogue output is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
Control card, 24 V DC output
Terminal number
Output voltage
Max. load
The 24 V DC supply is galvanically isolated from the supply voltage (PELV), but has the same potential as the analog and digital
inputs and outputs.
Control card, 10 V DC output
Terminal number
Output voltage
Max. load
The 10 V DC supply is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
96
VLT
Operating Instructions High Power
i
MG34Q202 - VLT
® Automation Drive FC 300 12-Pulse
®
is a registered Danfoss trademark
2/1
1) 2) 3) 3)
29 , 33 / 32 , 33
110 kHz (Push-pull driven)
5 kHz (open collector)
4 Hz
see
28 V DC
approx. 4 kΩ
Max. error: 0.1% of full scale
Max. error: 0.05 % of full scale
2
1)
27, 29
0 - 24 V
40 mA
1 kΩ
10 nF
0 Hz
32 kHz
Max. error: 0.1 % of full scale
12 bit
1
42
0/4 - 20 mA
500 Ω
Max. error: 0.5% of full scale
12 bit
12, 13
24 V +1, -3V
200 mA
50
10.5 V±0.5 V
15 mA