Control Cable - Husqvarna 536LiL Workshop Manual

8. Put all the components in the battery housing.
Attach the 2 screws to the control unit (G) and the 2
screws to the battery connector (H).
9. Assemble the battery housing. See
battery housing on page 37 .
10. Assemble the wear guard below the battery housing.
To disassemble the wear guard on page 21 .
See
11. Assemble the operating handle. See
the operating handle on page 37 .
5.14.1.2 For products with S/N: LiL, LiLX
2015080000-, LiR, LiRX/iRX 201510000-:
1. Remove the connector to the control unit.
2. Remove the connector to the keypad
3. Remove the connector to the main switch.
30 - Repair instructions
4. Put the fan in the battery housing. Make sure that
G
H
G
H
To assemble the
To assemble

5.15 Control cable

5.15.1 To disassemble the control cable
5.15.1.1 For products with S/N: LiR -2015100000:
1. Remove the operating handle. See
2. Remove the wear guard. See
3. Remove the power trigger lock and power trigger.
4. Remove the 4 screws and the 2 cable holders.
the rotating part of the fan points to the inner surface
of the battery housing.
handle on page 37 .
wear guard on page 21 .
To disassemble the power trigger lockout and
See
power trigger on page 37 .
Operating
To disassemble the
737 - 002 - 25.10.2018