Control Unit - Husqvarna 536LiL Workshop Manual

5.12.2.2 For products with S/N: LiL, LiLX
2015080000-, LiR, LiRX 201510000-:
1. Attach the connector (C) to the main switch. Apply
grease to the contact surfaces and the connector.
C
2. Connect the red wire (B) and the yellow wire (A) and
put the main switch in the battery housing.
3. Assemble the throttle trigger lock and throttle trigger.
4. Assemble the operating handle.
26 - Repair instructions
5.12.2.3 For products with S/N: LiLX/iLX
20180200201-, LiRX/iRX 20174900446-
1. Attach the cable (A) to the main switch and put it in
the battery housing.
2. Assemble the throttle trigger lock and throttle trigger.
3. Assemble the operating handle.

5.13 Control unit

5.13.1 To disassemble the control unit
5.13.1.1 For products with S/N: LiL -2015080000, LiR
-2015100000:
A
1. Remove the operating handle. See
handle on page 37 .
2. Remove the power trigger lock and power trigger.
See
power trigger on page 37 .
3. Remove the wear guard below the battery housing.
See
housing on page 36 .
4. Remove the battery housing. See
the battery housing on page 37 .
A
To disassemble the power trigger lockout and
To remove the wear guard from the battery
Operating
To disassemble
737 - 002 - 25.10.2018