Husqvarna 536LiL Workshop Manual page 25

3. Lift out the main switch and disconnect the gray wire
(A).
4. To disconnect the cable, release the catch (D) with a
small screwdriver and pull the connection (C) out.
D
D
5.12.1.3 For products with S/N: LiLX/iLX
20180200201-, LiRX/iRX 20174900446-
1. Remove the operating handle. See
handle on page 37 .
2. Remove the power trigger lock and power trigger.
To disassemble the power trigger lockout and
See
power trigger on page 37 .
3. Lift out the main switch and disconnect cable (A).
737 - 002 - 25.10.2018
A
C
Operating
A
a) To disconnect the cable, release the catch (D)
with a small screwdriver and pull the connection
(C) out.
C
5.12.2 To assemble the main switch
5.12.2.1 For products with S/N: LiL -2015080000, LiR
-2015100000:
1. Attach the connector (C) to the main switch. Apply
grease to the contact surfaces and the connector.
C
2. Connect the red wire (B) and the yellow wire (A) and
put the main switch in the battery housing.
3. Assemble the throttle trigger lock and throttle trigger.
4. Assemble the operating handle.
D
B
A
Repair instructions - 25