Husqvarna 536LiL Workshop Manual page 28

7. Remove the connector (D) for the keypad, main
switch and to the fan.
D
Replace the control unit
Replace the control unit to part number:
588 21 52-01 and 588 21 53-01 .
5.13.2 To assemble the control unit
5.13.2.1 For products with S/N: LiL -2015080000, LiR
-2015100000:
1. For products with S/N: LiL -2015080000
a) Connect the red wire from the battery connector
to the main switch.
2. For products with S/N: LiR -2015100000
a) Connect the red wire from the control cables to
the battery connector.
28 - Repair instructions
A
B
C
3. Connect the cables from the motor to the control unit
with (A, grey), (B, black) and (C, red).
4. Attach the yellow cable (D) to the control unit.
5. Attach the connector (E) to the keypad.
6. Attach the connector (F) to the fan.
F
A
B
C
7. Apply grease to the connector surface.
8. Put all the components in the battery housing.
Attach the 2 screws to the control unit (G) and the 2
screws to the battery connector (H).
9. Assemble the battery housing. See
battery housing on page 37 .
10. Assemble the wear guard below the battery housing.
To disassemble the wear guard on page 21 .
See
11. Assemble the operating handle. See
handle on page 37 .
E
D
H
G
H
To assemble the
Operating
737 - 002 - 25.10.2018
G