Dismantling The Control Cable Lir/Lirx - Husqvarna 536LiL Workshop Manual

Repair Instructions
9.11 Dismantling the control cable
LiR/LiRX
For products with S/N: 20151000001- (536LiR,
536LiRX).
NOTE!
Note how wires, components, etc., are
positioned before dismantling.
Make sure to position them correctly to avoid
pinching when the trimmer is reassembled.
1
Dismantle the operating handle.
Refer to "Basic dismantle/assembly".
2
Dismantle the wear guard.
Refer to "Basic dismantle/assembly".
3
Dismantle the throttle trigger lock and throttle trigger.
Refer to "Dismantling the throttle trigger lock and
throttle trigger"-
4
Loosen the screws (4x) and the cable holders (2x).
See figure 25b.
5
Lift out the main switch and disconnect the connector
(B) and the wire (A),
Dismantle the keypad and its cabling.
NB! See "Dismantling the main switch" for
a detailed description of disconnecting the
contact (C).
See figure 26b.
6
Dismantle the wear guard under the battery housing.
Refer to "Basic dismantle/assembly".
7
Dismantle the battery housing.
Refer to "Basic dismantle/assembly".
8
Dismantle the connector on the control unit.
See figure 27b.
9
Unhook the control cables from the clip on the
wear guard and loosen the cables from their
respective cable ducts.
Cleaning and inspection
Clean and inspect all parts of the control cable.
The cables must always be replaced with new
ones if cracked or showing signs of other defects.
Always use original spare parts.
See figure 28b.
52 –
English
Fig 25b
C
Fig 26b
Fig 27b
Fig 28b
B
A