Main Switch - Husqvarna 536LiL Workshop Manual

4. For products with S/N from: LiL, LiLX 2015080000-,
LiR, LiRX 201510000-. Put the wires through the
resistance (D). Connect the wires with (A, grey) at
the top, (B, black) in the middle and (C, red) at the
bottom.
A
B
C
5. For products with S/N from: LiLX/iLX, LiRX/iRX
201814XXXXX . Connect the wires with (A, grey) at
the top, (B, black) in the middle and (C, red) at the
bottom.
A
B
C
6. Assemble the battery housing. See
wear guard from the battery housing on page 36
7. Assemble the wear guard below the battery housing.
To disassemble the battery housing on page
See
37
8. Assemble the operating handle. See
handle on page 37
9. Assemble the trimmer guard. See
page 34
24 - Repair instructions

5.12 Main switch

5.12.1 To disassemble the main switch
5.12.1.1 For products with S/N: LiL -2015080000, LiR
-2015100000:
1. Remove the operating handle. See
2. Remove the power trigger lock and power trigger.
D
3. Lift out the main switch and disconnect the yellow
4. To disconnect the cable, release the catch (D) with a
To remove the
5.12.1.2 For products with S/N: LiL, LiLX
2015080000-, LiR, LiRX 201510000-
Operating
1. Remove the operating handle. See
Trimmer guard on
2. Remove the power trigger lock and power trigger.
handle on page 37 .
To disassemble the power trigger lockout and
See
power trigger on page 37 .
wire (A) and the red wire (B).
small screwdriver and pull the connection (C) out.
D
D
handle on page 37 .
To disassemble the power trigger lockout and
See
power trigger on page 37 .
Operating
B
A
C
Operating
737 - 002 - 25.10.2018