Make sure to put them correctly to prevent
damage when the product is assembled.
1. Remove the 6 screws (A) and the 4 screws (B) and
remove the right half of the wear guard.
B
2. Attach the left half of the wear guard to the shaft.
Use a cable tie to hold the cables against the shaft
and to prevent damage.
3. Assemble in the opposite sequence.
22 - Repair instructions
A
A
B
5.9 To replace the motor and drive wheel
136LiC, 336LiC/315iC
•
Remove the motor housing and replace it with a new
Trimmer guard on page 34 .
spare parts kit. See
5.10 To repair damaged threads
1. If the plastic threads in the chassis are damaged,
make a hole with a 4.5 mm drill bit.
2. Replace the original screw with the screw 503 21
74-16 - IHSCT MT5x16.
5.11 Motor
5.11.1 To disassemble the motor
1. Disassemble the trimmer head. See
trimmer head on page 19 .
2. Disassemble the trimmer guard. See
on page 34 .
3. Disassemble the operating handle. See
handle on page 37 .
4. Disassemble the wear guard below the battery
To disassemble the wear guard on
housing. See
page 21 .
5. Disassemble the battery housing. See
disassemble the battery housing on page 37 .
To replace the
A
A
A
B
Trimmer guard
Operating
To
737 - 002 - 25.10.2018
A