To Replace The Handle; To Replace The Shaft; To Disassemble The Wear Guard - Husqvarna 536LiL Workshop Manual

5.6 To replace the handle

1. Loosen the knob LiL, LiLX/iLX or the wing nut LiC/iC
and remove the parts from the shaft.
2. Assemble the new parts between the spacer and the
shaft.
LiC, iC
LiL, LiLX, iLX
Only LiLX, iLX

5.7 To replace the shaft

1. Disassemble the handle and the operating handle.
Operating handle on page 37
See
2. Disassemble the wear guard below the battery
housing. See To remove the wear guard from the
battery housing on page 36
3. Disassemble the battery housing. See
disassemble the battery housing on page 37
737 - 002 - 25.10.2018
4. Disassemble the trimmer line. See
replacement on page 17
5. Disassemble the motor. See
motor on page 22
6. Remove the 4 screws and the plate that hold the
shaft.
7. Replace the shaft and the plate if it is necessary.
8. Assemble the product in opposite sequence.

5.8 To disassemble the wear guard

To
CAUTION: Make a note of how the wires and
components are put before you disassemble.
Trimmer line
To disassemble the
Repair instructions - 21