Annunciators - Cardinal 210 Installation And Technical Manual

Annunciators are turned on to indicate that the display is in the mode corresponding to the
annunciator label or that the status indicated by the label is active. The annunciators flash on
and off to indicate that the indicator is waiting for input from the keypad for the mode indicated
by the flashing annunciator. Refer to Figure No.10 for location of the annunciators.
ZERO
This annunciator is turned on to indicate that the weight displayed is within +/- 1/4 division of
the center of zero.
 (STABLE)
This annunciator is turned on when the weight display is stable. When off, it means that the
change in successive weight samples is greater than the motion limits selected during setup.
NET
This annunciator is turned on to show that the displayed weight is the net weight (gross
weight less tare weight).
GROSS
This annunciator is turned on to show that gross weight is displayed. Gross weight will be
displayed when no tare weight is stored.
TARE
This annunciator is turned on to show that the displayed weight is the tare weight.
UNDER/PWC1
This annunciator is used to signal that the displayed weight is less than the minimum value of
acceptable weight used in the Checkweigher feature. Note that this annunciator is active
only when the Checkweigher feature is enabled.
The PWC1 annunciator is turned on to indicate that the displayed weight is equal to or
greater than the weight value stored as preset number 1. Note that this annunciator is active
only when the Preset Weight Comparator feature has been enabled.
ACCEPT/PWC2
This annunciator is used to signal that the displayed weight is within the acceptable weight
limits for the Checkweigher feature. That is, it is equal to or greater than the minimum
acceptable weight and equal to or less than the maximum acceptable weight. Note that this
annunciator is active only when the Checkweigher feature has been enabled.
The PWC2 annunciator is turned on to indicate that the displayed weight is equal to or
greater than the weight value stored as preset number 2. Note that this annunciator is active
only when the Preset Weight Comparator feature has been enabled.
OVER/PWC3
This annunciator is used to signal that the displayed weight is equal to or greater than the
minimum value of over weight used in the Checkweigher feature. Note that this annunciator
is active only when the Checkweigher feature has been enabled.
The PWC3 annunciator is turned on to indicate that the displayed weight is equal to or
greater than the weight value stored as preset number 3. Note that this annunciator is active
only when the Preset Weight Comparator feature has been enabled.
NOTE: PWC's 4 thru 8 do not have display annunciators.
8200-M585-O1 Rev D  210 Installation & Technical

ANNUNCIATORS

29