Output Voltages; Timing Characteristics; Led Indicator - Basler DART BCON SERIES User Manual

Physical Interface
4.3.3

Output Voltages

Pin Name Minimum
X1-; X1+ 1.125 V
X2-; X2+
247 mV
X3-; X3+
X4-; X4+
XCLK-; XCLK+
Table 9: Output Voltages (LVDS Outputs - Data Lanes and Clock Lines)
4.4

Timing Characteristics

Pin Min.
XCLK 20 MHz
X0-X3 140 Mb/s
I2C_SCL 0 kHz
Table 10: Timing Characteristics
4.5

LED Indicator

There is an LED indicator on the back of the camera board (see Figure 18 on
Green LED is ...
Dimming up/down
Lit permanently
Blinking rapidly
Table 11: LED Statuses
28
Nominal
(recommended)
1.25 V
-
Max. Notes
84 MHz Selectable via control interface.
Settable in steps of 8, i.e.
20 MHz, 28 MHz, 36 MHz, etc.
588 Mb/s Selectable via control interface.
400 kHz In the I²C-Bus Specification and
User Manual, this mode is called
"fast-mode" with 400 kbit/s.
The camera is being configured.
Camera is configured and operative.
Internal error.
Maximum Notes
1.375 V Common mode voltage
600 mV Differential voltage
Description
AW00136902000
page 23).
Basler dart BCON