Install The Flask Clips - Thermo Scientific SHKE8000 Series Maintenance Manual

Section 1
Installation

Install the Flask Clips

1-8 Model SHKE8000 Series Shakers
The Model SHKE8000/SHKE8000-ICE and SHKE8000-7/SHKE8000-
8CE accommodate glassware in numbers and sizes from ninety-one 25ml
flasks to six 2.8 liter flasks. All platforms have mounting holes for flask
clips and test tube racks made by other manufacturers.
Listed below are the flask clip assemblies and kits available for these
shakers.
Table 1-1. Available Flask Clip Assemblies and Kits
Dedicated Platform No. of
Number Clips
238066 91
238067 91
238068 40
238069 30
238070 40
238071 24
238072 15
238073 12
238074 6
Flask clips can be attached anywhere on the shaker platform. The
counterbalanced design of these shakers can accommodate an unbalanced
load.
The flask clips are supplied with the proper screws and are attached to the
platform with a standard Phillips screwdriver or with the screwdriver
provided with the unit.
Figures 1-15 and 1-16 illustrate the installation of the flask clips. Note that
clips for 1, 2 and 2.8 liter flasks use five screws. The 250/300ml flask clip
has an adhesive-backed flask cushion pad which is installed on the flat base
of the clip body. A hole is provided in the pad for the mounting screw.
Flask Size Springs per Clip
25 ml 1
50 ml 1
125 ml 1
250/300 ml 1 (w/ 1 lg pad)
250/300ml 1 (w/ 1 lg. pad)
500 ml 1
1 L 1
2 L 2 (w/ 10 tubes)
2800mL 2 (w/ 10 tubes)
Screws
per Clip
1
1
1
1
1
1
5
5
5
Thermo Scientific