Stacked Units On A Stand - Thermo Scientific SHKE8000 Series Maintenance Manual

Stacked Units on a Stand

Thermo Scientific
The stand for two units is shorter than the stand for a single unit for
operator convenience. Before installing the base unit onto this stand, place
the stand in its final location.
1. Add the neoprene pads to each of the stand leveling feet.
2. Place a 1-1/2 inch tall spacer over each hole in the top four corners of
the stand.
3. Remove the leveling feet from each shaker.
4. Carefully lift and position the shaker
over the spacers. Align the (4) mounting
holes in the bottom of the shaker with
the (4) spacers.
5. Assemble the lockwashers, then the D-
shaped flatwashers on the 1/2"-13 x 4"
bolts. Thread the bolts through the
underside of the stand top rails, through
the spacers and into the holes in the
bottom of the unit. Tighten these bolts
to secure the shaker to the stand. See
Figure 1-10.
6. Place a 1-1/2 inch spacer over each
of the four holes in the top corners
of the unit already on the stand.
7. Carefully lift and position the shaker
over the spacers. Align the (4)
mounting holes in the bottom of the
shaker with the (4) spacers.
8. Thread the 5/16"-18 x 4" bolts with
the required lockwashers and
flatwashers through the threaded
inserts, then the spacers, and into the unit
below. Tighten all bolts. See Figure 1-11.
bottom left corner
of shaker
1-1/2 in. spacer
4 in. bolt
D-flatwasher
lockwasher
top left corner
of stand
Figure 1-10. Stack on a Stand
bottom left corner
of shaker
lockwasher
flatwasher
4 in. bolt
1-1/2" spacer
top left corner
of base unit
Figure 1-11. Shaker on Base Unit
Figure 1-12. Stack on Stand
Model SHKE8000 Series Shakers
Section 1
Installation
1-5