General User Interfaces - Altera Cyclone III Reference Manual

Interfaces
Figure 2–4. Samtec Connector's Header
.78 REF
.571
(29 EQ Spaces @ .0197)
.150 REF
02
01
.036 REF
2–10
Cyclone III FPGA Starter Board Reference Manual
Table 2–8 lists the HSMC A connector board reference and manufacturing
information.
Table 2–8. HSMC A Connector Manufacturing Information
Board Reference
J1
The HSMC uses the Samtec connector's header provided on the board.
Figure 2–4 shows the outline of the Samtec header.
2.413
((90 POS / 30 x .7875) + .050)
.626 REF
DP Bank

General User Interfaces

To allow you to fully use the I/O capabilities of the Cyclone III device, the
following user interfaces are available on the board (remaining I/Os are
connected to additional board resources):
■
Push-buttons: System and user reset, and user-defined push-buttons
■
LEDs: Board-specific and user-defined LEDs
Some of the board's buttons and LEDs have a specific board function
while others are user-defined and are provided to control FPGA designs.
Description Manufacturer
High speed Samtec
Mezzanine card
connector
.006 REF
Manufacturer
Part Number
ASP-12953-01
.245 REF .285 REF
Altera Corporation
April 2012