5. PMA Calibration
UG-20056 | 2019.02.04
Related Information
•
PMA Attribute Details
•
PMA Attribute Codes
•
Reconfiguring the Duplex PMA Using the Reset Controller in Automatic Mode
page 140
5.1. PMA Calibration Revision History
Document
Version
2019.02.04
Made the following changes:
•
Added link to Reconfiguring the Duplex PMA Using the Reset Controller in Automatic Mode.
•
Added reminder: Refer to PMA Attribute Codes for information on which attributes can only be
changed when the PMA is disabled.
2018.07.18
Made the following changes:
•
Added instructions to PMA Calibration: When dynamically reconfiguring the PMA to a different
datarate, you need to recalibrate the PMA. The PMA calibration is run when the PMA is enabled, so
you first disable the PMA.
•
Added the "Wait for tx_pma_ready and rx_pma_ready ports to assert" block to the "Enabling PMA
Calibration" figure.
2018.05.15
Made the following changes:
•
Added instructions to enable/disable the PMA using PMA attribute code 0x0001.
•
Added the "Changing a Setting When the PMA Cannot be Running" flowchart.
2018.01.31
Initial release.
Send Feedback
on page 129
on page 170
Changes
Intel
®
®
Stratix
10 E-Tile Transceiver PHY User Guide
on
99