Parts List; Choosing And Preparing A Suitable Work Surface; Electrical Requirements - Newport 6100 User Manual

32 Getting Started
3.3

Parts List

The following is a list of parts included with the Model 6100 Laser Diode
and Temperature Controller:
1. Start Up Guide (Hardcopy).
2. CD with Software Drivers and Utilities, User's Manual, Start Up Guide.
3. IEC320 AC line cord with a NEMA 5-15P, or country-specific,
4. Mating connector for the Temperature Controller output connector.
5. Mating connector for the Laser Diode Driver output connector with the
6. A pair of keys for the safety keyswitch.
If you are missing any parts or have questions about the parts you have
received, please contact Newport Corporation.
3.4

Choosing and Preparing a Suitable Work Surface

The Model 6100 Laser Diode and Temperature Controller may be placed on
any reasonably firm table or bench during operation.
3.5

Electrical Requirements

Before attempting to power up the unit for the first time, the following
precautions must be followed:


connector.
interlock jumper installed.
To avoid electric shock, connect the instrument to properly
earth-grounded, 3-prong receptacles only. Failure to observe
this precaution can result in severe injury.
Have a qualified electrician verify the wall socket that will be used is
properly polarized and properly grounded.
Provide adequate distance between the Models 6100 Laser Diode and
Temperature Controller and adjacent walls for ventilation purposes. Do
not let any other equipment blow hot air towards the Laser Diode and
WARNING