Using The Tubespec Probe-Data View - Argus TubeSpec User Manual

Chapter 6: Using OrionNET Software
Alarms and warnings must be configured through other OrionNET controls (see "Working with Controls
in the View Designer or Viewer" in the OrionNET Software User Guide). The alarms and warnings appear
on the chart view as shaded regions in the chart-plotting-area background, and as outlines in the chart-leg-
end display area.
The user may use the OrionNET digital-display controls that appear across the top of the default chart view to
configure alarms and warnings.
Alarms display as red shaded areas; warnings display as yellow shaded areas.
In the screenshot below, a warning has been configured on a channel to display if the channel-value
descends below .118 inches.

Using the TubeSpec Probe-data View

The Argus TubeSpec probe-data view design is a grid (spreadsheet) display of all channel measurements as
reported from the TubeSpec.
The TubeSpec probe-data view appears in the OrionNET Viewer similarly to the 
following:
Min, Avg, and Max values are only calculated when their related UT sensor-channels are enabled. UT sen-
sor-channels are displayed regardless of whether or not they are enabled.
Enable/disable individual UT sensor-channels by clicking their number in the header.
74 NOV CTES Argus TubeSpec User Guide