Front Fork; Hardware Torque - Taylor-Dunn SC-100-24 Service And Replacement Parts Manual

SC-100

FRONT FORK

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Note: It is recommended to replace the grease
seal any time the fork is removed from the
vehicle.
1: The front of the vehicle shall be supported on jack
stands just high enough to install the fork.
2: Place the lower bearing in the fork collar and
install a new grease seal.
3: Apply a light coat of grease to the collar bearing
races.
4: Insert the fork up through the fork collar and lower
bearing being careful not to damage the grease
seal.
5: Hold the fork up in the collar and install the upper
bearing, spacer, and spindle nut.
6: While rotating the fork to the left and right, torque
the spindle nut to 85 foot pounds.
7: Loosen the nut 1/4 turn and then re-torque to 65
foot pounds.
MA-100-03

HARDWARE TORQUE

Description
Ball Joint Clamp
Rod End Stud Nut
Rod End Jam Nut
Ball Joint Castle Nut
Steering
Foot Pounds Newton Meters
28-32 37.9-43.4
20-25 27.1-33.9
20-25 27.1-33.9
40-45 54.2-61
Page 55