Center The Steering Wheel - Taylor-Dunn SC-100-24 Service And Replacement Parts Manual

SC-100

Center the Steering Wheel

1: Position the front fork in the straight ahead position and tie it off so that it cannot rotate.
2: Remove the steering chain access plate.
3: Remove the safety wire from the turn buckles and discard.
4: Loosen the turn buckles just enough to remove the chain from the lower sprocket
5: Center the steering wheel as shown in the illustration and tie it off so that it cannot rotate.
6: Position the chains so that the turnbuckles are an equivalent distance from the steering wheel sprocket. See
illustration to the right.
7: Install the chain on the lower sprocket.
8: Tighten the turnbuckles to remove all play from the steering chain.
9: Install new safety wire and tie off as shown in the illustration.
10: Untie the front fork.
11: Reconnect the main positive and negative cables at the batteries.
12: Remove the blocks from behind the wheels.
13: Release the parking brake and test drive the vehicle.
MA-100-03
Steering wheel removed for clarity
Steering
Page 51