Taylor-Dunn SC-100-24 Service And Replacement Parts Manual page 20

Tool List
TOOL LIST
The tools shown here are generic for
servicing Taylor-Dunn vehicles. Not all tools
will be required for servicing this vehicle.
41-532-50: Chain Case Centering Tool
Used to center the chain case cover on all
vehicles equipped with the Power Traction
primary reduction and a pinion brake or speed
sensor. Includes instructions.
62-027-61 and -62: Sevcon System
Handset
Diagnostics and adjustments (-62 only)
of the Sevcon Power Pak and Micro Pak
control systems.
Page 20
62-027-32: Throttle Module Analyzer
Tests the throttle module in or out of the
vehicle
43-201-50: Pinion Seal Installation Tool
Used to install the pinion seal on all vehicles
equipped with the Power Traction primary
reduction and a pinion brake or speed
sensor.
Controller Programming:
Sevcon: 62-027-63 "PCpaK Cable lead and application."
Curtis AC: 62-027-66 "1314 PC Programming Station"
75-089-00: Throttle Module Test Harness
Used in conjunction with a volt meter to test
the throttle module. The module must be
installed in a working control system.
Note: Part # 62-027-31 includes instructions
62-027-00: Test Light
Used for testing electrical circuits. Switchable
for 12, 24, 36, 48 volt systems.
Required to complete troubleshooting
provided in the vehicle service manuals.
62-027-64 and -65: Curtis AC System
Handset
Diagnostics and adjustments (-65 only) of
the Curtis AC control system.
MA-100-03
SC-100