Transaxle Identification - Taylor-Dunn SC-100-24 Service And Replacement Parts Manual

Table of Contents
Transaxle - GT
Transaxle Identification...................................31
Check Oil Level ................................................32
Change Oil ........................................................32
Axle Shaft .........................................................33
Remove ...................................................................33
Install .......................................................................33
Rear Hub, Rotor & Bearings ...........................34
Motor Removal .................................................34
Primary Gear Case ..........................................35
Secondary Gear Case .....................................36
Disassemble ............................................................36
Assemble .................................................................37
Pinion Bearing Preload ...................................38
Pinion Gear Shimming Instructions .........................38
Set Pinion Bearing Preload .....................................38
Hardware Torque .............................................39

TRANSAXLE IDENTIFICATION

Your vehicle may be equipped with one of two types of transaxle assemblies. This section covers the
SD transaxle.
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in
the Service Guidelines chapter.