Transaxle-Gt; Check Oil Level; Change Oil - Taylor-Dunn SC-100-24 Service And Replacement Parts Manual

Table of Contents

Advertisement

Transaxle-GT

CHECK OIL LEVEL

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Fluid type and capacities are listed in the lubrication
section in the General Maintenance chapter.
Note: The oil flows freely between the main
gear case (3rd member) and the primary
reduction gear case. It is only necessary to
check the oil level of the 3rd member.
1: Place an oil drain pan underneath the 3rd
member.
2: Remove the fill/level plug.
3: The oil level should be very close to the bottom of
the level plug opening.
a. If the oil level is below the bottom of the opening,
add oil as required until level with the bottom of
the opening. Refer to the Lube Chart section for
information regarding type of oil.
b. If oil comes out of the opening, allow to drain until
level with the bottom of the opening.
4: Replace the fill/level plug.
5: Reconnect the main positive and negative cables
at the batteries.
6: Remove the blocks from the wheels.
7: Release the park brake and test drive the vehicle.
Page 32

CHANGE OIL

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
1: Raise the rear of the vehicle and support with
jack stands.
2: Place a four quart drain pan under the drive
assembly.
3: Remove the drain plugs from the differential case
and gear case.
4: Once the oil has drained, replace the drain plugs
and lower the vehicle to the ground.
5: Remove the fill/level plug and fill the diferential up
to the bottom of the level plug opening. Refer to
the Lube Chart section for information regarding
type of oil.
6: Replace the fill plug.
7: Reconnect the main positive and negative cables
at the batteries.
8: Remove the blocks from the wheels.
9: Release the park brake and test drive the vehicle.
Primary reduction case drain plug
SC-100
MA-100-03

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-100-36Sc-100-48

Table of Contents