Taylor-Dunn SC-100-24 Service And Replacement Parts Manual page 21

SC-100
96-500-43: PMT/C Meter Reset Module
Required to reset the PMT/C maintenance
meter (special order option).
77-200-00: Hydrometer
Used for testing battery electrolyte.
Illustration is of a typical hydrometer, actual
hydrometer type may vary.
Molex # 11-300-02: Pin Removing Tool
Removes 0.062 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
MA-100-03
41-350-13: Disc Brake Boot Installation Tool
Assists in installing the rubber boot onto the
disc brake piston.
72-201-00: Battery Filler
Used to safely add water to batteries.
Equipped with splash guard and auto-
shutoff when cell is full.
Molex # 11-300-06: Pin Removing Tool
Removes 0.093 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
Tool List
70-440-55: Pin Removing Tool
Removes pin from Amp circular harness
connectors.
96-500-48: GT Drive Oil Fill Plug Tool
Used to remove the oil fill plug on GT
drives. It is used with a 3/8" drive extension
(not included).
75-442-55: Pin Removing Tool
Removes pins from Molex Mini-Fit harness
connectors.
Page 21