Inspect The Parking Brake; Wheel Park Brake (Mechanical Disc) - Taylor-Dunn SC-100-24 Service And Replacement Parts Manual

SC-100

INSPECT THE PARKING BRAKE

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.

Wheel Park Brake (Mechanical Disc)

The parking brake is actuated through the same linkages
as the service brake. Refer to Inspect the Service Brake
section to inspect the brake pads.
WARNING
• Make sure the key-switch is in the "OFF" position,
then remove the key.
• Place the forward-reverse switch in the center
"OFF" position.
• Set the park brake.
• Place blocks under the rear wheels to prevent
vehicle movement.
• Disconnect the main positive and negative cables
at the batteries.
1: Inspect all brake cables and linkages for any
signs of damage or missing cotter pins.
2: Inspect the park brake handle for any signs of
damage or wear.
3: Set the park brake.
4: Reconnect the main positive and negative cables
at the batteries.
5: Remove the blocks from the wheels.
MA-100-03
WARNING
If any sign of damage or wear is found on the park
brake handle, cables, or linkages then they must be
repaired or replaced immediately. Failure to repair
or replace any damaged component could result in
failure of the park brake causing severe bodily injury
and/or property damage.
Brakes
Page 59