Table of Contents
Advertisement
Section 5 – Operation
5.1-12 Driving forward or reverse using
platform control console
NOTE
The general direction of the turret and boom
relative to the chassis indicates the forward
direction of motion.
1. Depress and hold footswitch.
2. On platform control console, move and hold
drive/steer controller to drive forward or
backward.
3. Release controller handle to stop.
CAUTION
The drive orientation can change when the turret is
swung 90 degrees off center of the normal driving
position (roughly when boom is swung past the
rear tire). Drive re-orientation will not occur while
driving and rotating until the joystick is released
for 6 seconds or when the footswitch is released.
CAUTION
The forward direction of travel will be in the
general direction the counterweight is facing while
reverse will be the opposite. Care should be taken
to confirm the counterweight orientation prior to
activating any drive/steer functions.
CAUTION
When driving on a slope:.
DO NOT exceed the rated gradeability listed in
▪
Section
7.4.
5.1-13 Steering using platform control
console
1. Depress and hold footswitch.
2. On platform control console, press rocker on top
of drive/steer controller to steer left or right.
NOTE
Driving and steering may be active at the same
time.
213213AAA
60
5.1-14 Moving jib up and down using
platform control console
1. Depress and hold footswitch.
2. On jib up/down switch, select to move jib up or
down. Release switch to stop.
5.1-15 Rotating jib using platform control
console
1. Depress and hold footswitch.
2. On jib rotation switch, select to rotate jib left or
right. Release switch to stop.
5.1-16 Moving riser up and down using
platform control console
1. Depress and hold footswitch.
2. On riser up/down switch, select to move riser up
or down. Release switch to stop.
5.1-17 Extending or retracting fly boom
using platform control console
1. Depress and hold footswitch.
2. On boom extend/retract switch, select to extend
or retract fly boom. Release switch to stop.
5.1-18 Rotating platform using platform
control console
1. Depress and hold footswitch.
2. On platform rotation switch, select to rotate
platform left or right.
5.1-19 Leveling platform using platform
control console
1. Depress and hold footswitch.
2. On platform leveling override switch, select
up position to tilt platform up or down position to
tilt platform down.
5.1-20 Raising or lowering main boom
using platform control console
1. Depress and hold footswitch.
2. Push and hold boom/turret controller to raise or
lower main boom.
3. Release controller handle to stop.
Start Operation
SJ30 AJE SJ30 ARJE
Advertisement
Table of Contents
